for Cold Climate Housing and much more

Specialty - Cross Cuts

Shelving often requires evenly spaced identical width slots.  These do not need to be all measured out.  The key is an indexing jig. 

In a latter video we will use this indexing jig to make box joints.

 

Learning Curve 122


Add A Comment

  Your Comments

Showing 2 comments

Viewing from newest to oldest – Reverse
controlsgirl on January 31, 2024 10:19

Great video. How did he make the spacer?

Hello Controls Girl,

You could make a spacer by simply cutting a small piece off of the end of a 1x2 -- but the grain would be running across the spacer making it easy to break. So if you rip into the end of a 1x2, then cut off your little piece you get a sturdy piece of wood for a spacer. You could calculate : slot width less thickness of the kerf, usually 1/8"; but you will probably have to test the spacer to see what it gives you and adjust. Make it slightly too thick, and then sand it down to perfection. If it gets too thin, either start over, or glue on a thin piece of plastic or edging trim with contact cement (paper would wear off too easily).

jon

Roger on November 20, 2019 21:50

GREETINGS... love these table saw videos. The one titled "Specialty Cross Cuts" doesn't play and the video codex in three different browsers doesn't load to view this one. Is there something I'm doing wrong?

yup-- we missed converting this one from Flash to mp4 -- done. Thanks to everyone who helps to keep this site working.
jon

Add A Comment

I encourage you to help develop the topic of this page by sharing your advice/comments/wisdom/personal experience/etc on this specific subject through the form below. Although I have developed most of this site with the encyclopedic concept of research and verification of information—I cannot vouch for anything contained in the comments below, but I may pick up, develop and include ideas put forward here into the primary entries. Please sign your name so we know who to give credit to. Your picture will show up next to your comment, here and elsewhere, if you sign up with Gravatar - jon

Please note that comments now need to be approved before appearing on the site to combat spam problems.
Sorry for the delay!