Jon Eakes
Ask Jon Eakes
for Cold Climate Housing and much more

Table Saw Basics Videos

Cross Cut - Drifting

Using the miter gauge is often a tiring task because of gripping so hard with your hand to keep the wood from slipping, or drifting when butting angles less than 90 degrees. 

In an earlier video we "dressed the guide" with sandpaper to reduce this slipping.  In this segment we put that dressed guide into action and even look at how to identify the point of entry for the blade, without even scratching the wood.

 

« Last Watched « Previous Next »

Learning Curve 117

Add A Comment

Showing

Viewing from newest to oldest – Reverse
Subscribe by RSS

Be The First To Add A Comment

I encourage you to help develop the topic of this page by sharing your advice/comments/wisdom/personal experience/etc on this specific subject through the form below. Although I have developed most of this site with the encyclopedic concept of research and verification of information—I cannot vouch for anything contained in the comments below, but I may pick up, develop and include ideas put forward here into the primary entries. Please sign your name so we know who to give credit to. Your picture will show up next to your comment, here and elsewhere, if you sign up with Gravatar - jon

Please note that comments now need to be approved before appearing on the site to combat spam problems.
Sorry for the delay!