Connect to your favourite weather forecaster and look for the following conditions:
Category: Roofing Product: Plastic Cement / cold applied Roof Patch
Temperature Limitations: Varies by product: Use above -5 C (+23 F) to above freezing
Rain Limitations: Varies by product: dry to underw...
Glue or Adhesive?
What is the difference between a glue and an adhesive? Only vocabulary, although often Glue is the term used for DIYers and Adhesive for professionals -- or for some Glue is liquid and Adhesive is gunned from a tube with a caulking gun or applied with a notched trowel. Whether...
Bill from Paradise, Newfoundland writes: "I need to settle a bet between a buddy and myself. When you put in a vinyl window should a drip cap always be used? My buddy never uses one, and claims water never gets in under the window."
Well Bill, you win. Yes you should always put a flashing over t...
Probably one of the best ways to learn about good and bad building techniques is to work on the renovation or restoration side of the construction picture. Here is where you see the results of everything done before, especially when the results are a failed system. In the world of ceramic, stone ...
Connect to your favourite weather forecaster and look for the following conditions:
Category: Adhesives Product: Epoxy - Wet-Bond
Temperature Limitations: Above +10 C (+50 F) -- although a special product called "Cold-Bond" will work at -6 C (+21 F)
Rain Limitations: Can be applied in r...
The best way for air to move through a duct is to have a straight duct with a smooth inside wall and a round form will have the smallest surface area to cause the air to slow down. That straight smooth round duct is what is considered the benchmark for good ducting.
Everything else is measure...
In all too many new houses, there is a seasonal problem where in the winter the ceiling actually lifts itself right off the wall in the centre of the house, and then settles down after the heating season. Even in some older houses this goes on every year.
What causes this crack?
Avoiding...
Truss uplift causes cracks between the wall and the ceiling that open and close every year and you cannot plaster or caulk them shut. For details on the cause and solutions to this problem follow this link.
If you cannot do the major work required to prevent this crack from opening, or you j...
Cutting crown moldings can be simple and it can be difficult.
First you want to check if the corner you are putting the molding into is in fact 90 degrees. If you don't check that you can get real frustrated with your mitre saw. 88 or 92 degree walls require different mitre cuts.
Over the years...
Although it is possible to purchase real wood doors or have them custom made, more and more kitchens have one form or another of plasticized doors, generally made of MDF (Medium Density Fiberboard, compressed wood fibres) and covered with various plastics, acrylics or polymers.
Plastics were fi...
