for Cold Climate Housing and much more

Found 444 results for the keyword ‘Techniques’

  • Hole Saws: Automatic plug ejectors & the 1 tooth saw

    When you use a hole saw, it is often very difficult to get the plug out of the saw cup when you are done. More and more manufacturers have provided slots on the side of the hole saw to allow you to jam a screwdriver in and pry the plug out. But this is often not so easy. (By the way, the larger t...
  • Teaching Kids Woodworking -- reaching for success

    Over the years I have had the occasion to teach working with tools to kids as young as 3 years old.  At whatever age the secret is to know the individual kids attention span and prepair the work to give them a feeling of completion and success within those limits.  Regular sessions of success and...
  • A Retracting Latch for a Gate that Swings toward the street

    Gates that swing out towards the street present a serious problem for latches.  If you mount the latch on the gate itself, it will not work unless you install it on the street side.  Out on that side it is simply not secure.  If you mount it on the fence, then the shaft that catches the gate is a...
  • Double glue for difficult tiles.

    When you want to attach tiles where you would have to support them while the adhesive dries, like on a sloped surface or a ceiling, Chester from Metochosin, BC has a solution. Put the ceramic adhesive around the outside edge and then apply some hot glue to the centre. Push it into place and hold...
  • Getting trim to stick to the edge of panels.

    There are quite a variety of techniques and tricks to getting trim to stay put on the edge of a particle board or plywood panel. Many plastic and metal trims come in a 'T' shape. This requires you to cut a groove down the centre of the panel edge, just the right width and well centred to receive ...
  • Properly spreading glue

    Woodworking requires glue and a good glue joint is one that has just the right quantity of glue spread evenly over the entire surface being glued. When you run the glue bottle down the edge of a board and simply push up another board, the glue tends to spread out as in the first photo, where I am...
  • Oscillating Tools

    MATERIAL REMOVAL

    Table Saw Basics

    Dressing the Table

    Table Saw Basics

    Basic Cross Cutting

    Table Saw Basics

    Specialty Cuts