Floor mouldings and crown mouldings were originally all made out of heavy plaster or real wood. Then they were produced out of MDF or compressed sawdust. Now you can find them made out of plastics and drywall as well.ProFlex is a rubber like moulding that is the champion at following curves...
Carol from Smith Falls has a new home but has had water running down her basement walls from the beginning, and no one, not even her builder, seems to be able to figure out why. As well, the problem seems to get better and worse with time, but still wet.
First of all you need to keep in mind tha...
Anne painted her bathroom with latex paint and then started to get mould and mildew where she never had any before. She is wondering what she did wrong?
Mould is caused by the prolonged presence of condensation. Condensation is caused by a combination of high humidity and low temperatures. If yo...
I hate to put exhaust ducts through roofs, because there will always be some condensation that could drip back inside. I would much rather go through a side wall, or down and out the side of the basement. But if you must go up and through the roof...
Don't allow your ducting to have any loops in...
Gerry is reshingling an open beam low sloped roof that has always given him problems with ice dams. He wants to know if it is worth it to tear up the first four feet, install air sheets and replace the boards?
Actually it is a great idea to perfect the over-the-wall section of the roof space any...
Often in constructing a house, the sequence of putting up walls, applying outside sheathing and installing insulation batts can leave the outside corner as a hollow spot with no insulation. The carpentry work was done and the hollow corner closed and hidden before the guys with the fiberglass eve...
Rodney from Hamilton Ontario asks "why is there a bulkhead over most bathtubs? Every home I remodel seems to have the ceiling above the tub furred down about one foot."
First of all Rodney, bulkheads are not a requirement of any kind and as far as I know, never were. In fact, they are a very reg...
Ken in Sault St.Marie wants to paint his bedroom but has mildew on the outside corners.
Anywhere where there is wood and no insulation in the walls, like where studs and other framing go right through the wall, we have a thermal bridge that cools the drywall more than where there is insulation. ...
SPELLING
First, a simple spelling problem. Is it 'mold' or 'mould'. According to the dictionaries, the two are equivalent, with 'mould' being primarily a British variation. But mold is active and dynamic, and dictionaries are slow in comparison. According to the Canada Mortgage and Housing Co...
The national building code requires a minimum level of insulation in a basement that reaches about two feet below the outside grade level. The objective is to make this storage space a heatable space. Hence some materials and techniques have developed that satisfy this minimum code requirement th...
