This hot glue gun runs for 75 minutes on a propane recharge. You can even adjust the temperature of the hot glue. G800C Butane Gas Cordless Glue Gun $39.95 from Marcan Adhesives Corp. in Montreal.
Here is a special bit and guide to put on your Dremel. It is specifically made to remove grout from between ceramic tiles, quickly and easily. Grout Removal Attachment Kit
Hitichi let me play with a prototype of a portable machine that will bend re-bar to any shape you want, with absolutely no effort. Expensive and used for heavy construction sites -- but a really nifty gadget. It is like playing with re-bar like they were paper clips.
Here is a battery operated machine that makes clean cuts in all sizes of continuous thread bolts, leaving them ready to receive the nuts - made by Hitachi.
Here is a little fan that just sits on top of the heating grill. It senses hot air and turns on to add some boost to the air flow in an area that doesn't get enough heat. It is called the Register Booster by Field Controls.
Here is a little fan called the "Air Booster" by Field Controls that is already installed inside a duct. You just cut into a ventilation or heating duct and replace a little section with this little fan and you can get a boost to the air flow. In-line fans can do the same thing with more power,...
This is a great one handed edge clamp.
You put the large "C" shaped gadget over the wood and begin to turn the handle.
The upper and lower clamping pads move in to grab the main sheet.
Once they grip, then the side clamp moves forward to secure the trim on the edge.
When they have all gripped...
This is a special story.
The biggest hole saw you can find on the shelves of hardware stores across Canada is 6 inches. All the companies stop at 6.
But you can't put the new 6" ventilation ducts through a 6 inch hole, you need a little more. So I personally pushed Starrett Tools to see if they...
I was amazed how easy it is to paint in "faux grain" using this funny little rubber tool.You just apply the wood stain and then drag the tool along, rocking forward and backward to open and close grain lines. It is amazingly realistic and surprisingly easy.It is called a "ZAR Graining Tool".The ...
"Big Foot" is a plastic form that you put in the bottom of the hole you dug for your support columns. You then set a Sono-tube on the top and pour in the concrete. The concrete will fill the form on the bottom (air holes let it flow) and give you a perfectly formed footing every time, without h...
