Riana from Huntsville Ontario is struggling with getting the miter cuts right for crown molding.
First rule, use a large miter box (purchased, rented or home made) that allows you to make simple 45 degree with the molding standing up in its regular position. Well, almost in its regular position....
When you are working on getting trim to fit tightly around a window, be sure to perfect the mitre corners first, and then cut the square length last. That way, if you have to adjust the mitre, you still have enough length to the wood to fit the other end.One way to assure a perfect fit is to rou...
Brad from Surry, B.C. has strange angles to his walls, and he wants to put crown molding around the top. How to cut the angles?Don't even try with your compound angle power miter box. Build a simple jig. A piece of plywood for the base, which represents the ceiling. (The molding is always ...
Crown molding is traditionally cut at a straight 45 degree miter with the molding sitting upright in the miter box. The only trick here is to realize that the saw bed is the ceiling, and the saw fence is the wall, so your molding is sitting upside down in the box. That was fine when we used...
One of our viewers is looking to redo all the trim in his house so he is wondering which mitre saw he should buy.
The variety is very confusing but there are two basic types:
Fixed mitre boxes that go up and down. They will cut mitres, angles to the right or the left and most of them will cut...
Truss uplift causes cracks between the wall and the ceiling that open and close every year and you cannot plaster or caulk them shut. For details on the cause and solutions to this problem follow this link.
If you cannot do the major work required to prevent this crack from opening, or you j...
Cutting crown moldings can be simple and it can be difficult.
First you want to check if the corner you are putting the molding into is in fact 90 degrees. If you don't check that you can get real frustrated with your mitre saw. 88 or 92 degree walls require different mitre cuts.
Over the years...
