for Cold Climate Housing and much more

Glue Line Rip Blade

Ripping is the action with a circular saw that requires the most power from the saw because rather than dust, it is actually pulling out small rips of wood, not to mention the greater potential for the wood to squeeze in on the blade. 

Here you will learn about the geometry of the ripping blade, even a special one made by Freud designed to give you a smooth enough rip edge to go right to glue-up.  For a lot more detail about the problems of ripping wood on a circular saw, check out the "Basic Rip Cutting" section in the "Table Saw Basics" video set here in the Learning Curve. 

 

Learning Curve 133


Add A Comment

  Your Comments

Showing 1 comment

Viewing from oldest to newest Reverse
Tim S Firman on October 10, 2018 18:17

Matching up the piece being ripped off, to the piece it was ripped off from, in the same orientation, is a far different scenario, than joining to totally separate pieces of wood, and i'm not referring to specifically the grain matching . This method is the same as double cutting wallpaper, where any wavering of the cut is equally offset in the mating piece.

Add A Comment

I encourage you to help develop the topic of this page by sharing your advice/comments/wisdom/personal experience/etc on this specific subject through the form below. Although I have developed most of this site with the encyclopedic concept of research and verification of information—I cannot vouch for anything contained in the comments below, but I may pick up, develop and include ideas put forward here into the primary entries. Please sign your name so we know who to give credit to. Your picture will show up next to your comment, here and elsewhere, if you sign up with Gravatar - jon

Please note that comments now need to be approved before appearing on the site to combat spam problems.
Sorry for the delay!